It’s little secret that stepper motors are everywhere in FDM 3D printers, but there’s no real reason why you cannot take another type of DC motor like a brushless DC (BLDC) motor and use that instead.

Another day, another Nacon controller review from TheSixthAxis! In all seriousness, we’ve been putting Nacon’s range of controllers to the test these past few years and this latest unit is a surprise ...

Making airplanes with foam board is really handy since this material is very cheap, easy to work with, and durable. It's the same material the channel Flite Test uses in their builds. I recently tried ...

This article features deals sourced directly by Gizmodo and produced independently of the editorial team. We may earn a commission when you buy through links on the site. Reading time 2 minutes Drone ...

Hot glue guns are pretty simple beasts: there’s an on/off switch, a heating element, and a source of current, be it battery or wired. You turn it on, and the heater starts warming up; eventually you ...

Abstract: In the servo system, input signals often easily reach a state of saturation, resulting in the discrepancies between the controller's output and the actual application requirements. To ...

Abstract: Smooth movement and constraint satisfaction are the key safety and effectiveness concerns of visual servoing systems of logistics transport robots. In this article, we propose a novel ...

A library for Arduino that provides functions to configure and operate the SAA1057 PLL integrated circuit. This library enables control over various aspects of the PLL's operation.